3

A spliced joint makes very little difference to an HF antenna electrically, but if you do solder it then you should protect the solder joint from the weather, because the solder will corrode faster than the wire. Right-angle turns in the wire will affect the radiation pattern, but since the radiation pattern of a "random" length wire antenna is funny-...


2

Ham radio is about experimenting, Wire antennas are relatively cheap to make. Go ahead and try it and see how well it works. I am not sating you should not read about various antennas and ask other people's opinions. You should, but at the end of day go ahead and try it. In my experience splicing wires should not be an issue. mechanically fasten the wire ...


2

Splicing the wire is just fine electrically, but if you're using multistranded cable you probably won't want to solder it. Soldering makes a stiff section which concentrates the stress at the joint, leading to premature failure. Swaging is ideal, but if you don't have the necessary tool then rope clips are an acceptable alternative.


1

Yes, you can. If you want it to stand up physically for a long time, you should Make a good, strong splice. To make a "lineman splice" you strip several inches of each wire, overlap them, and closely wrap each one around the other one, as in this diagram (A through D are the four steps of one variation; E and F are other variations with slightly wider ...


Only top voted, non community-wiki answers of a minimum length are eligible