4
votes
How to use HT microphone with two jacks (Kenwood connector) as a substitue for KX-3 microphone?
The Elecraft rigs have flexible interfaces for alternate microphone settings. However, there is only the single TRRS plug for a Microphone on the KX3. You should be able to wire up your own ...
- 2,868
4
votes
Accepted
Can I have a signal generator on while it's not connected?
It's not necessary to turn it off while it is not connected. Zero dBm is a power level of only 1 milliwatt, and no device will be damaged by that power level.
If it were, the manual would have said ...
- 7,515
3
votes
Accepted
How to use HT microphone with two jacks (Kenwood connector) as a substitue for KX-3 microphone?
In the end I decided to build a simple adapter. Most handheld microphones available at cheap prices have two-jack "Kenwood compatible" interface. They have 3.5mm TRS jack and 2.5mm TRS jack.
The ...
2
votes
Can I have a signal generator on while it's not connected?
From Elecraft support:
"You do not have to connect a load to the XG3. A signal generator is different from a transmitter."
- 740
Only top scored, non community-wiki answers of a minimum length are eligible