Skip to main content

Questions tagged [rssi]

Received Signal Strength Indicators, also known as the "bars" that display your signal reception. Questions about how they work and how to use them belong here!

Filter by
Sorted by
Tagged with
1 vote
1 answer
51 views

Printing the Signal Power on the terminal from the USRP source block on GNURadio

I'm working on a project that makes use of the Ettus USRP X300 and the GNURadio environment. I have established a connection between the transmitter and the receiver of the USRP and I'm able to read ...
Abhiram Prakash Alamuri's user avatar
2 votes
3 answers
154 views

Wireless signal strength explanation needed

Could you kindly explain me or advise following please... I have a TP-link WiFi router. When I measure signal strength just in the vicinity of the router- literally I touch my smartphone (with WiFi ...
mariolucas's user avatar
1 vote
3 answers
127 views

Can I measure position with antenna/receiver?

I hope this question is not out of bounds. I'm a EE with little RF and you guys seem to know a LOT about RF... I have a small vehicle traveling in a straight line at low speed. I need to know when it ...
RayZ's user avatar
  • 11
3 votes
3 answers
2k views

How to Measure Signal Strength

I am building several types of radio antennas, and I would like to test which is the most effective. I am wondering: What is the best way to measure the strength of the received signal? It is at ~151 ...
Danny's user avatar
  • 33
2 votes
3 answers
514 views

RSSI on both ends of UHF Point to Point network do not match

My understanding of an RSSI reading is that it should equal Tx power - Tx feed loss + Tx antenna gain - pathloss + Rx antenna gain - Rx feed loss. If this is the case, if the radios at either end are ...
epv's user avatar
  • 21
2 votes
1 answer
1k views

How to measure received signal strength, using DIY circuit

I use 2.4GHz receivers for flying my RC planes via FPV. So i can get best reception i use multiple antennas on multiple video receivers. I have a diversity controller that uses noise in the video ...
Ben's user avatar
  • 347
9 votes
1 answer
2k views

Digital-mode signal reports

When operating analog voice, we give a qualitative (or possibly just arbitrary) signal report, 'scoring' the signal either out of a maximum 'five by five', or a maximum '599'. How do you report the ...
Dan KD2EE's user avatar
  • 3,966