Questions tagged [receiver]

Use this tag for questions about the theory and structure of receivers.

9 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
6
votes
1answer
621 views

Doppler Shift Compensation in Inter Satellite Communication

I am currently doing a project in the area of optical inter-satellite communication (GEO-LEO). I am using a optical carrier of 281 THz, and the Doppler shift corresponding to it is ±7 GHz. I ...
4
votes
0answers
64 views

Commercial Loopstick Antenna Manufacturers

Not sure this is the right forum for this but I thought I'd give it a shot. I am an electrical engineer working on a product that needs a loopstick antenna. I had thought that AM radios were so ...
2
votes
0answers
88 views

Unknown kit from DK0TV

When my father - who became a ham years after I did - passed away, I found an unstarted project (board + components), which I only re-discovered again years later. The board is marked DK0TV-001, and ...
2
votes
0answers
83 views

Has this regeneration control been done?

I'm planning to build a two-tube reflexed RF regen receiver soon. I'm examining methods of controlling the regeneration — it needs to be possible to both initiate and halt oscillation in all bands (I ...
1
vote
1answer
21 views

PSR500/Pro106/WS1040 Phase II Upgrade?

I want to know if one can upgrade the hardware chips/ the CPU/DSP inside police scanners to do Phase II. I know they cannot do Phase II due to hardware/software limits but if whistler can upgrade ...
1
vote
0answers
67 views

Using SW radio to detect Jupiter

I read here (in the ideas section) that an old shortwave radio can be used as a receiver for listening to Jupiter but am unsure about how to do it. MY radio has both a whip and ferrite antenna, ...
0
votes
0answers
14 views

Combining two CFU455IT +/-2kHz (4kHz) ceramic filters to get a +/-1.25kHz (2.5kHz) filter for SSB

Can I put two of these cheap (less than 3USD) and common CFU455IT +/-2kHz (4kHz bandwith -6dB ) ceramic filters in series to get a lower bandwidth good for SSB TX? If I'm correct I will get -12dB at +/...
0
votes
0answers
15 views

What configuration of a BJT IF amp can I use for a superhet receiver?

I am making a superhet SSB CW receiver with a crystal filter on the input after the mixer. Do I have to use IF transformers as the coupling method? Or can I use capacitor coupling with resistors as ...
0
votes
0answers
57 views

Is there any 2.4 GHz tuner ICs for SDR receivers?

I have a hackrf one sdr, which i use to transmit test signals. I am using ISM bands, so I can omit transmitting my callsign, checking correct sub band (FM, digital) etc. And one of most interesting ...