All Questions
4 questions
1
vote
1
answer
255
views
Advice on keyer: two paddle on old Kenwood with 'straight key' only
I am using a Kenwood TS-130S, which has only a 1-pole jack for the key (it is a 1/4" telephone jack, aka "monoaural", tip and barrel only). I know that I need to have an aftermarket ...
- 11
1
vote
1
answer
66
views
On KENWOOD TS2000, the CW messages don't record even after the "recording wait" pops up in the display. But the sidetone works fine
I'm working on a miniproject where i'm asked to demonstrate the recording of some signal.
I made a keyer connection using a earphone cable to my Kenwood. The Keyer works fine - the sidetone is audible ...
- 11
2
votes
2
answers
299
views
Connecting a Katsumi Elekey EK-150 to my transceiver
I picked up a used Katsumi Elekey EK-150 (manual) electronic keyer.
I'm trying to get it working with my Kenwood TS-570S (manual), which has a 3.5mm Key jack. With a male-male audio cable connected to ...
- 185
2
votes
1
answer
4k
views
Decoding the Morse code
I am using a crystal to transmit morse codes, and I am using Kenwood radio receiver to obtain the signal. It receives the signal with a lot of noise, though we can figure out the morse code sound. I ...
- 123