Questions tagged [impedance-matching]

Questions about fixed impedance matching networks, the necessity of impedance matching, etc.

4 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
5
votes
0answers
157 views

How to estimate input and output impedance of an amplifier?

I'm trying to figure out how to design power amplifiers which input and output are properly matched to 50 Ohm. My thinking was that the most bullet proofed approach would be to model an amplifier in ...
1
vote
0answers
26 views

S-Parameters Power amplifier impedance matching

I recently decided to conceive a 10W class 446MHz amplifier. I want to be able to amplify a 100mW signal into a 10W, for that i'm going for a two stages amplifier : SKY65162 to amplify the signal to ...
1
vote
0answers
38 views

Crystal Filter Impedance Matching

I downloaded a 2-meter receiver schematic using an IC for the dual conversion IF strip. The first 10.7MHz IF uses a crystal filter with a terminating impedance of 1800//5pF. The output impedance of ...
0
votes
0answers
29 views

Titan antenna VSWR and radio problem

I just installed a new Titan DX antenna and I am using psk31 with fldigi. When I transmit on 20m at 14072, the SWR is 1.65 and it shuts off my computer and the radio keeps transmitting. However, on ...