Stack Exchange Network

Stack Exchange network consists of 174 Q&A communities including Stack Overflow, the largest, most trusted online community for developers to learn, share their knowledge, and build their careers.

Visit Stack Exchange

Questions tagged [end-fed-antenna]

The tag has no usage guidance.

4
votes
4answers
139 views

Does a 1/2 wavelength end-fed antenna need a good RF ground?

I was searching for DIY end-fed antenna. Some of the articles I found say that for a 1/2 wavelength end-fed I need a "small to no counterpoise" (with a lambda*0.05 m counterpoise), but some other ...
0
votes
1answer
37 views

Do I need an 9:1 UNUN for a half-wave end fed?

I was using a 10-ish meter wire as my HF rx antenna. That's all I can install in my QTH. However I realised that my ~10 m wire can be turned into an end fed dipole for 20 meter band. But there is a ...
0
votes
0answers
26 views

Required length for 20 meter end fed aerial [duplicate]

I have an 40 meter end-fed aerial 66 feet long. Can this be shortened to tune to 20 meters (say 28ft), as I need it to be resonant on 20 or 40 for QRP work. The question is, What would be the required ...
4
votes
1answer
1k views

Do end-fed dipole antennas need choke baluns?

I have a couple of end-fed wire antennas I bought that came with matching baluns. One has a 9:1 unun, and I'm not sure about the other one. In addition to those, should I also put a choke balun on the ...
4
votes
3answers
254 views

Suggestions for HF antenna for occasional use on my sailboat

I have had a license since I was a kid, but have not touched anything ham radio related in years. I have been thinking about diving back in and combining it with my sailing. I'm looking for thoughts ...
7
votes
6answers
3k views

What is the impedance of an end-fed half-wave antenna?

It is my understanding that the feed-point impedance ($Z_a$) of an end-fed half-wave antenna is dependent on at least the following factors: $L_a$: The length of the radiating element of the antenna. ...
1
vote
0answers
87 views

Antenna Impedance calculation for low frequency [duplicate]

If I have an end fed long wire in free space, say 100 ft, how do I calculate its $R$ & $X$ at different frequencies?
1
vote
1answer
541 views

Do a toroid's specs matter much in an antenna matching transformer?

I'm getting started with my first (very basic) HF rig and for convenience and the experience I'd like to try an End Fed Half Wave antenna. Typical designs for a "matchbox" in this case include ...
3
votes
2answers
814 views

Dipole versus ungrounded end fed for HF RX

I've built a 2 meter ground plane antenna that works pretty well for RX and has a decent SWR on 2 meters with my Alinco. However, I'm experimenting with SDR quite a bit and would really like to build ...
5
votes
6answers
18k views

End-fed wire antenna lengths

I want to use an end-fed wire antenna, but what would be the best length of wire for the 20m and 40m bands? Is there a way to work this out? This is assuming a tuner will be used.