Questions tagged [audio]

The tag has no usage guidance.

Filter by
Sorted by
Tagged with
11
votes
4answers
358 views

How do I increase my phone intelligibility?

Listening to various operators at different times, I've sometimes noticed, especially during contests, that some operators are easier to understand than others, and it doesn't all seem to be due to ...
6
votes
3answers
552 views

Is there a special term for amateur transceiver speakers or anything that makes them different from any other kind of speaker?

When I bought a secondhand FT-7800R at Field Day 2017, I received an MLS-100 external speaker with it. I installed it recently and having the speaker more than an inch away from the radio's mounting ...
3
votes
1answer
182 views

Transmitted audio coming out through my speaker

I have a Kenwood TS590 HF transceiver. When I am transmitting and speaking into the microphone, I can hear my audio slightly coming out of my speaker connected to the radio (SP-23), or headphones if ...
3
votes
1answer
2k views

What cable is needed in order to record audio from a Baofeng UV-5x3 on a computer?

I would like to be able to connect my radio to my computer in order to record audio. It seems like this would just be a matter of getting the right cable, but after trying a few cables (listed below), ...
2
votes
4answers
539 views

Suitable acoustic foam rubber for headphones?

These are photos of the headphones that I use in my ham shack. As you can see, the dark gray foam rubber inside is deteriorating, and I need to replace it. It appears to be open-cell foam "rubber" ...
2
votes
1answer
92 views

why does net control hear a check-in which I do not hear?

Sometimes on a net, net control acknowledges a check-in that I haven't heard. That is, I hear some check-ins but not others. Not poor signal, just silence. But net control hears it. Why might that be? ...
2
votes
1answer
190 views

What is an Audio Peaking Filter?

What is an Audio Peaking Filter? And how might that be different from an ordinary (narrow) CW bandpass filter, or from tunable audio filters (with fully configurable upper and lower cutoffs)? Does a ...
1
vote
1answer
133 views

Looking for a convenient audio frequency spectrum analyzer

I would like to have a convenient tool to measure filters and amplifiers in 20 Hz - 20 kHz frequency range. Currently I'm doing this with a signal generator, an oscilloscope and LibreOffice. It's not ...
1
vote
2answers
122 views

Audio being sent over ground pin on audio jack

I just bought a QYT KT-8900D mobile radio. One of the first things I've noticed is that I cannot use my mixer to completely lower the volume of the radio's 3.5mm TRRS output. When the fader is all the ...
1
vote
1answer
310 views

Design/Build a DIY Audio Attenuator and Splitter

I’m trying to be less of an appliance operator. To that end, I recently came up with a simple project that I thought I could figure out and build entirely on my own. I was wrong. My goal was to ...
1
vote
0answers
48 views

Audio Interface wiring diagram of Yaesu FT-65 TNC cable

I want to imitate this cable, but I don't know-how. Yaesu FT-65 TNC cable. Is it need to series a resistor inside of those?
0
votes
1answer
58 views

Audio too high, how to troubleshoot

I am using a TYT TH-9800 with a 10 m half dipole antenna on low power (5 W) to connect to a WIN linked repeater (+5.0 MHz offset and 123.0 tone). I made contact with two other stations and was told ...
0
votes
0answers
56 views

Is 6 kHz bandpass filter wide enough for listening to SW broadcasts?

I'm considering buying ICOM IC-718 as a main rig and also to use it for SWL. Read contrasting opinions on the Internet, with an article reviewing dedicated SW receivers saying "That receiver's ...
0
votes
0answers
143 views

Writing "Wav" file in GNU Radio 3.9.0

I need to burn an audio file received from a computer sound card. But in the new version of the gnu radio, I found that the "Wav File Sink" and "Wav File Source" blocks were gone. ...