Questions tagged [antenna-tuner]

Questions relating to the setup and use of antenna tuners, the virtues and shortcomings of various types of tuners, etc.

Filter by
Sorted by
Tagged with
7
votes
3answers
2k views

What is the actual loss in a feed line with high SWR?

It is well-known that it is unwise to have standing waves on the feed line between one's antenna and one's transmitter, unless it is a very low-loss type (e.g. ladder line), because the transmitted ...
18
votes
3answers
8k views

Why do I need to tune an antenna?

I've heard that when an antenna is set up, it needs to be tuned to reduce reflective power back into the radio. Is this always necessary, and if so how would I go about tuning it?
10
votes
5answers
3k views

What is an antenna tuner? Why bother with resonant antennas in the first place?

There are a lot of antenna tuners on the market that have various capabilities in terms of how they can allow random radiators to work with our transceivers. What exactly do they do? My ...
5
votes
2answers
1k views

Adapting an antenna coupler

I've built AA5TB's antenna coupler: I left out C2 because I didn't understand why I would need it - why would I? It works fine without. Unfortunately, when I started tuning for a 5W 20m transceiver, ...
8
votes
4answers
1k views

Two Antenna Tuners in Series

My radio has an internal antenna tuner that can be activated to rapidly tune for the frequency in use. My antenna has a disgusting SWR for the band I want to use (as measured with an AA-54 antenna ...
4
votes
3answers
5k views

Antenna tuner design

In a related question about a broadband antenna for SDR it was suggested me to build or buy an antenna tuner. Since maybe it was not clear to everybody, I'm designing an antenna tuner for reception, ...
2
votes
5answers
3k views

Balun and tuner configuration for multiband dipole

I'm putting up a multiband dipole in some tall trees. (Perhaps it's more correct to call it a "dipole-doublet"). The situation I'm imagining looks like this: The legs of the antenna are each 100 ...
14
votes
12answers
16k views

How can I safely transmit without an antenna tuner or SWR meter?

Just what the title says. An Antenna Tuner, henceforth AT, is almost a de facto piece of equipment in a shack; working the bands without one is tantamount to leaping off the diving board into a ...
8
votes
1answer
634 views

Antenna tuning while receiving

I've built AA5TB's antenna coupler for a 5W 20m transceiver. Tuning was kind of difficult because my transceiver has buttons for sending a dot and a dash, but no tuning mode, so I couldn't have the ...
6
votes
2answers
1k views

Does a tube based HF transmitter need an antenna tuner?

With the adjustments on a transmitter such as a Yaesu FT-101E, is there any purpose for an antenna tuner, or can you accomplish the same thing by adjusting the loading and other controls?
8
votes
2answers
570 views

What types of materials increase the inductance of a coil when inserted inside it?

I'm asking this because of the comments in this answer, that imply that steel (mostly iron) has similar characteristics to ferrite. Specifically, it is implied that inserting solid steel into a ...
4
votes
3answers
2k views

Do I need an 9:1 UNUN for a half-wave end fed?

I was using a 10-ish meter wire as my HF rx antenna. That's all I can install in my QTH. However I realised that my ~10 m wire can be turned into an end fed dipole for 20 meter band. But there is a ...
9
votes
2answers
1k views

Why is the risk of damage to a transmitter due to a mismatched antenna at lower frequencies greater?

A quick follow-up to this answer ... If the impedance mismatch is large, you risk damaging your radio, particularly on the lower frequencies ... I'm sorry to be so dense, but uh why is the risk ...
3
votes
1answer
1k views

Is ladder line necessary when using a non-resonant dipole through a tuner?

I've heard if I have a dipole of some arbitrary length, or a random wire, the SWR can be very bad. An antenna tuner can present a decent match to the transmitter, but the SWR on the feedline will be ...
2
votes
2answers
485 views

Adapting an antenna tuner for use with a panel meter instead of an LED

I'm building NorCal's / W6JJZ's BLT tuner (pdf) for use on 40m/20m with a 5W transmitter. I would like to remove the LED and use a small panel meter instead. I don't have a 1N34A at hand, but I do ...
1
vote
1answer
42 views

Bidirectional motor control using MFJ-4116 with RCS-4

I have the RCS-4 with two MFJ-4116. Prior to installing my motorized HF antenna system topside, I bench-tested the core of the assembly in my shack. The MFJ-4116 near my transceiver was injected with ...
1
vote
2answers
259 views

Rotary Inductor Replacement

I thought it was time to build a balanced-balanced antenna tuner so I mechanically ganged two B&W 3852 rotary inductors to make a balanced L network. It appears that the 16 uH inductors I used ...