Linked Questions

2
votes
1answer
1k views

Connecting a coaxial cable as feed to a halfwave dipole

I have as assignment to make a half wave dipole antenna, that radiates at 433 MHz. I am trying to figure out how to use a coaxial cable as transmission line. I know that the coaxial cable is ...
6
votes
4answers
4k views

Why do we distinguish between balanced and unbalanced?

I hear all the time, "you need a balun between your balanced dipole and unbalanced coax to stop the common-mode current" when it seems the proper advice is "you need something to stop common-mode ...
1
vote
1answer
664 views

Grounding plan for new ham shack - good/bad idea?

I have been researching and trying to plan out how to run the grounding/cables for a new ham radio room that will be in a new cabin being built. Since I am starting with dirt, I should have ...
2
votes
2answers
319 views

Measurement Confusion

I am building a simple antenna from this article 7db for 7 bucks. I am confused on the measurements for the antenna: It looks like there are two pieces of 18 inch PVC pipes connected to a T fitting. ...
4
votes
3answers
585 views

Is RF current always confined to the inner diameter of a braided outer conductor of coaxial cable?

Prompted by a previous question found at Using a balun with a resonant dipole -- an answer there included the following text: "For transmission lines (twin-lead or coax) to not radiate, each ...
4
votes
1answer
1k views

Antenna, input and ground bonding

I'm new to this and am in need of guidance. I am mounting a multi-band antenna on a 50 foot tall 1 1/4" galvanized mast. I plan to drive a ground rod at the base of the antenna and bond the mast to ...
13
votes
3answers
7k views

How do I prevent radio signals from tripping a GFCI?

My wife woke up several nights by a metallic "thunk". It happened to be while I was talking on 10 meters and turned out to be the ground fault circuit interrupter (GFCI) on her hair dryer cord. ...
2
votes
2answers
1k views

Grounding Help - Where To Route My Wires

Here is my situation. My antenna mast is on the opposite side of the house from my ham shack, same with the power service entrance. I have installed ground rods roughly every 16 feet with #6 wire ...
2
votes
3answers
2k views

What does it mean to have “RF in your signal”?

I've been told that I have "RF in my signal". What does this mean? What are some potential causes of having RF in the signal?
3
votes
3answers
888 views

Unexpected Resonance - Dual-Band Dipole

I tried to make a dual-band (2m/70cm) dipole this morning by following the instructions on this page: http://www.amateurradio.bz/2m-70cm_vertical_dipole_antenna.html, with the rather major significant ...
1
vote
1answer
605 views

How to assemble an antenna (impedance matching methods)

I got the following plans off Martin E. Meserve's website. How do I go about assembling the antenna once I have the elements and boom? What is the impedance of the driven element? Do I need baluns ...
6
votes
2answers
1k views

Dipole Antenna Current Distribution at any Time Instant

Above is a connection of half-wave dipole antenna. The book states that the current profile is same at any given time instant on both the radiators, each of quarter wavelength length. Now my ...
7
votes
8answers
10k views

How does the length of a metal sleeve around a (shieled) coax cable affect antenna performance?

A post on http://adsbexchange.com/forums/topic/beginners-2-cantenna-easy-diy-antenna-to-improve-rangeplane-count uses a $\frac{\lambda}{4}$ sleeve made of a pop can beneath a $\frac{\lambda}{4}$ wire ...
3
votes
1answer
94 views

How much distortion would aluminium wire stays for the centre-pole on my inverted-vee cause?

I used nylon rope from the nearest hardware store to stay the centre-mast on my inverted-vee for the 20. The centre-pole is a long long looong bamboo. The trouble is rain here really isn't friendly to ...
14
votes
4answers
6k views

What does the addition of a shield to a small loop accomplish?

A small shielded loop is an antenna with a loop of wire, smaller than 1/10th of a wavelength in diameter, also surrounded by a shield. Often, they are constructed from coax. There is a gap in the ...

15 30 50 per page