Linked Questions

19
votes
5answers
8k views

How can I protect equipment against a lightning strike?

A lot of aerials (almost by design) would be rather good attractors of lightning. What steps do I need to take in the field to keep my gear safe against a lightning strike? I'm presuming the obvious ...
13
votes
3answers
6k views

How do I prevent radio signals from tripping a GFCI?

My wife woke up several nights by a metallic "thunk". It happened to be while I was talking on 10 meters and turned out to be the ground fault circuit interrupter (GFCI) on her hair dryer cord. ...
11
votes
2answers
4k views

How to reduce RF in the shack when using vertical HF antenna (no radials)

What can be done to reduce RF in the shack (riding back along the coax) when using a vertical 10M antenna (without radials due to space constraints)? The antenna is an IMax-2000 at 32' elevation (20' ...
14
votes
2answers
3k views

If I install a G5RV in my attic how could I be certain there are not harmful levels of RF in the shack, or my kids bedroom?

I assume that anyone who has a G5RV or G5RV junior in their attic has done so with ceramic spacers, and has zigzag or dog-leg installations, or otherwise has contorted the antenna to fit up there. My ...
5
votes
2answers
7k views

How to construct a loop antenna for receiving HF?

I have a unused hula-hoop in my garage, and I ran some stranded speaker wire around it once, and attached one side of the wire to the coax shielding, and the other to the coax core wire. Is this the ...
12
votes
3answers
4k views

Is there an optimum Antenna Feedline Length for mobile installations?

I bought a ham radio antenna mounting kit for my car that includes ~16' of coax. One end has a trunk lip NMO antenna mount, the other end has a re-solderable PL-259. I asked the sales person if it is ...
9
votes
2answers
8k views

Grounding VHF base station antenna

I'd like to install an outdoor dual band VHF/UHF base station antenna, a simple pole antenna like the Comet GP-1. I live in an area where lightning is rare, but not unheard of. Should I drive ground ...
12
votes
3answers
10k views

Where are the baluns for VHF and higher? How can one be made?

In another question, commenters recommended that I look into adding a 1:1 balun to a dual-band dipole to eliminate the feedline as a radiator. As I understand it, a 1:1 balun also functions as a choke,...
5
votes
5answers
501 views

Signal path to maximize RFI rejection in an urban environment

Urban ham here (Cambridge, MA - FN42ki - KC1JZE) looking for tips to make this hobby possible in the city. I rarely can hear both sides of HF phone transmissions, and have yet to make contacts despite ...
2
votes
4answers
6k views

How do you construct a 1:1 balun?

I have been researching how to construct a 1:1 current balun. I have a few questions and am looking for feedback on what I plan to do. First, I want to use the balun from 10m to 160m at 100w. I plan ...
5
votes
3answers
892 views

Is this the Correct Ferrite Core to Reduce RFI as a Common Mode Choke?

I have a Flex 3000 connected via RG-11 coax to a inverted V fan dipole tuned for 40m and 20m on my roof. I have an "ugly" balun up on the mast by the antenna. I further have the feed-line going into a ...
5
votes
2answers
3k views

How to measure a balun for effectiveness?

It seems there are almost as many "balun" designs as there are web pages about "baluns". There's lots of accusations pointed in all directions ("design Z isn't a balun OR a choke", "design Y is ...
7
votes
1answer
2k views

How to determine number of turns for a 1:1 balun?

I would like to make a 1:1 balun with М1000НМ ferrite core (magnetic permeability - 1000) and 1 mm thick copper wire using triple bifilar winding. Unfortunately I didn't manage to find a clear ...
8
votes
2answers
1k views

High 40m noise floor during the evening but quiet in the afternoon

I've been dealing with S7 static on 40 meters ever since I got started a few weeks ago. It's so bad that I have to use my RF ATT so that the static is not deafening. I did some research about ...
4
votes
2answers
3k views

Does effective grounding of mobile (vehicle) antenna mounts address common-mode currents?

While researching how best to install my mobile amateur radio in my car, I didn't understand if there was optimum Antenna Feedline Length for mobile installations? Understanding that this is caused ...

15 30 50 per page