3
$\begingroup$

With vacuum-tube-based transmitters, you'd need to tune the output finals to achieve maximum power output, and this was commonly done into some sort of dummy load (either a purpose-made dummy load or something simple like a light bulb) while aiming for maximum power output on or near the desired operating frequency.

However, solid state equipment doesn't need the finals tuned to the operating frequency. On the other hand, they are much more sensitive to antenna impedance mismatches.

Seeing that antenna impedance mismatches are not caught or solved by first tuning into a dummy load, in what situations is a dummy load useful with a purely solid-state transmitter (where any external amplifier is considered part of the transmitter)?

$\endgroup$
6
$\begingroup$

Any time you don't want to transmit RF. For example, if you have an oscilloscope and spectrum analyzer and would like to test the output of your transmitter (e.g. to make sure it's on frequency, that the waveform is OK and not getting cut off, that you don't have any spurious signals being transmitted) you might want to transmit into a dummy load rather than an antenna to prevent interfering with another transmittion and taking up bandwidth that you don't really need.

It can also be helpful to test your transmitter's power output in the absence of any SWR mismatch or reflected signal.

| improve this answer | |
$\endgroup$
  • 1
    $\begingroup$ I'd also add that they can be quite handy when the thing you want to transmit to is a receiver a few feet away, for testing. $\endgroup$ – Phil Frost - W8II Oct 29 '13 at 22:14
  • $\begingroup$ Yeah that's a valid point $\endgroup$ – Dan KD2EE Oct 29 '13 at 22:17

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.