I'm looking for a simple way to impedance match an array of two 50 Ω antennas so that when they are combined they appear as one 50 Ω load.

Assume that both antennas are identically constructed, are in phase with one another, and have the same VSWR very close to 1. The frequency the antennas are tuned to is 2.4 GHz.

Is there a simple “rule of thumb” method that I could use that requires little equipment?


The canonical solution to this problem is a Wilkinson power divider. There are of course other power dividers, but the Wilkinson is easy to fabricate, provides good isolation between the output ports, and is lossless when the output ports are equal and in phase, which is true for an ideal antenna array.

If you were to make one of these yourself, you'd probably do it with coax. However, it's easier to illustrate with microstrip:

microstrip power divider

P1 would be connected to your transmitter, and P2 and P3 to your antennas.

Between P1 and P2, and also between P1 and P3, are quarter-wavelength transmission lines having an impedance of $\sqrt 2 \cdot Z_0$. For your case that works out to $\sqrt 2 \cdot 50 \Omega = 70.7\Omega $. 75 ohm coax is close enough and easier to find.

Between P2 and P3 is a resistor that's twice the characteristic impedance. For your case, that's $100\Omega$.

Made with coax, it looks something like this (click for bigger version):

coax power divider

Although it's not impossible to fabricate this sort of thing yourself, doing so at 2.4 GHz is a bit of a trick, especially if you don't have test equipment. 2.4 GHz is a very popular band, and this is a very common device, so you won't have any difficulty finding a pre-made solution for purchase.

  • $\begingroup$ Looks ideal for the scratch builder, can it be used to combine greater than 2 antennas so long as they are all of the same impedance and phase? $\endgroup$
    – Ben
    May 7 '14 at 18:48
  • 1
    $\begingroup$ @Ben It can, in two ways. You can cascade them together, ie, power dividers feeding power dividers. This works great when the number of outputs is a power of 2. Somewhat less commonly, Wilkinson dividers can be constructed with an arbitrary number of output ports. The resulting layout gets pretty hairy though, and can't be realized in two dimensions, so cascading dividers can be the simpler approach. $\endgroup$ May 7 '14 at 22:21

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.