4
$\begingroup$

Several months ago, before I had a Transceiver that worked, I configured FLDIGI to graphically display the letters QC 13P in the waterfall as a preamble to my PSK31 transmission. I remember I was looking into Reed Solomon identifiers or Hellschreiber or something else to tell hams what mode I was using. I would like to remove this from my PSK31 signal. The only problem is I forgot how I did it and I can't find where I configured FLDIGI to work like this. Is it time to reinstall FLDIGI? Will that configuration persist through the reinstall? How do I undo what I did?

$\endgroup$
3
  • 1
    $\begingroup$ I figured it out. I had video IDS check marked under Configure/IDS/Video $\endgroup$
    – user141802
    Mar 28, 2020 at 23:07
  • 1
    $\begingroup$ You could post that as an answer and click the checkmark $\endgroup$
    – mike65535
    Mar 29, 2020 at 1:21
  • 1
    $\begingroup$ Yes, as @mike65535 said, you should post that as an answer, and then check it (mark it as accepted). Otherwise, the system will keep pushing this to the top. Plus, you'll get a few bonus points! :-) $\endgroup$ Mar 29, 2020 at 4:11

1 Answer 1

7
$\begingroup$

I figured it out. In FLDIGI I had video IDS check marked under Configure/IDS/Video. Here is the link to a video on YouTube that clearly explains what I needed to know. https://youtu.be/nwkz0GNpA0I

$\endgroup$
0

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .