# Will using a 1:1 balun at the feedpoint of a center feed dipole result in no common mode current on the outside of the coax?

Will using a 1:1 balun at the feedpoint of a center-fed dipole when using coax result in no common mode current on the outside of the coax ?

• What do you mean by Using an "RF choke" to block common mode current is a band-aid? Sep 23, 2019 at 14:00
• I removed your other question and opinion to conform to SE guidelines. Otherwise, it's a good question. Sep 24, 2019 at 21:14

Depends on how much current you mean by no current.

But in general, unless the dipole is actually perfectly symmetrical, in a perfectly symmetric environment, above a symmetric ground, with the feed line at exactly 90 degrees all the way into the far field, and/or with the radio equipment and their ground connections also exactly 90 degrees perpendicular to the dipole, any of those could cause asymmetry in the RF field around the antenna, which could then couple into the outer coax (and any other nearby conductive objects).

It might be possible to reduce that coupled current into the coax shield by positioning chokes which can increase the impedance to asymmetric RF fields, if any.

But odds are that if you were to place a short receive antenna anywhere along your coax, exactly parallel to it, you would pick up the transmitted signal. And if that short receive antenna is picking up RF, so is the much longer coax.

• Excellent point, and I edited my answer accordingly. It would be helpful to see some models comparing a symmetrical dipole with varying degrees of asymmetry. Sep 24, 2019 at 21:04
• Another way to check the presence of a common mode current is to measure SWR while moving the coax. With a balun you will see almost no changes in SWR plot (the coax doesn't radiate, i.e. doesn't work as a part of the antenna). Without the balun SWR will change significantly. Sep 25, 2019 at 9:39

Yes. If the balun is properly designed, there will be little to no common mode current on the outside of the shield.

It is almost always good practice to use an effective choke balun at the feedpoint of any center-fed balanced dipole. The exception would be if some vertical radiation was helpful and the coax was not picking up RFI.

Hotpaw2 makes some excellent points about being symmetrical in his answer. I doubt whether a "small" amount of asymmetry would cause a significant amount of common-mode, but that would have to be determined by either experimenting or modeling.

Regardless of the amount of asymmetry, the choke balun would help; however, at some point it would become necessary to add a choke farther away from the feedpoint.

Here are some past questions and answers I found searching for Balun center dipole.