Can I add a center-frequency parameter for my noise generator flowgraph, is there a different noise source that has this parameter other than the generic noise source block?

enter image description here

  • $\begingroup$ the Noise source doesn't have something like a center frequency. And your Audio Sink can't support 2.2 MS/s. We address sampling rates in the Official Guided Tutorials. $\endgroup$ Sep 16 '19 at 19:14
  • $\begingroup$ @MarcusMüller, Thanks! $\endgroup$
    – Hadad
    Sep 16 '19 at 20:11

The noise from that block doesn't have a center frequency because it's "white" — it has an equal power at any frequency (up to the half the sample rate, anyway, and you can extend that as far as you need). You can give it a shape by filtering it. Whatever the shape of the filter is, will be the shape of the resulting noise power. If you run it through a bandpass filter with a given center frequency, then the noise will have that center frequency.

  • $\begingroup$ Outstanding. Thanks a lot. $\endgroup$
    – Hadad
    Sep 17 '19 at 18:08
  • $\begingroup$ Does the same thing apply when using Low Pass Filter? $\endgroup$
    – Hadad
    Sep 17 '19 at 18:14
  • 1
    $\begingroup$ @Hadad a lowpass doesn't have a center, it has a cutoff. $\endgroup$ Sep 17 '19 at 19:12
  • $\begingroup$ Where is the center frequency in the bandpass filter, is it the average of the low and high cutoff frequencies? $\endgroup$
    – Hadad
    Sep 17 '19 at 19:31
  • $\begingroup$ @hobbsKC2G, can I shape the noise with the center frequency of the USRP device? $\endgroup$
    – Hadad
    Sep 19 '19 at 17:40

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.