2
$\begingroup$

I'm looking for info on demodulating both sides of an ISO14443 communication using a cheap SDR, preferably an RTL-SDR (R820T2+RTL2832U). The application is passively monitoring an NFC exchange for debugging purposes (like this or this specialized tools allow), using a pickup coil next to the devices. I'm restricting to ISO/IEC 14443-2:2010 (which covers some of the most-used NFC modes).

Operation uses magnetic induction at fc=13.56MHz (an ISM band). The field is generated by the reader (aka PCD), with a TRP often up to 1W. It is picked-up by a card (aka PICC) at like up to 100mm. The PICC's antenna is typically a coil (like 60mm diameter, 3 turns), connected to an (integrated) capacitor forming an L(R)C tuned slightly above fc, followed by a rectifier for power extraction. The PICC transmits by load modulation of a sub-carrier at fs=fc/16=847.5kHz. That creates sidebands (e.g. at fc±fs).

PCD transmission is ASK ≈10% NRZ-L (or [*] ASK ≈100% modified Miller). PICC transmission is BPSK NRZ-L (or [*] OOK Manchester). Bit rates are fs/8, fs/4, fs/2, sometime fs (≈106, 212, 424, sometime 848 kbit/s), negotiated independently in each direction.
[*] These modes are for the so-called "type A" at fs/8 bit rate.

Issues designing a circuit between the pickup coil and SDR:

  • the 13.56MHz field can be strong (>4V RMS for each turn of an unloaded 60mm diameter pickup coil) and should not fry the SDR
  • that 13.56MHz field varies enormously (?-25dB) depending PCD, PICC, and position of a pickup coil (and to a lesser degree according to internal activity in the PICC, which varies between communication bursts).
  • the 847.5kHz sub-carrier is comparatively very weak (?-40dB), and also very variable depending on devices and placement of a pickup coil.

Info, links, ideas (even half-baked) welcome.

New contributor
fgrieu is a new contributor to this site. Take care in asking for clarification, commenting, and answering. Check out our Code of Conduct.
$\endgroup$

Your Answer

fgrieu is a new contributor. Be nice, and check out our Code of Conduct.

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Browse other questions tagged or ask your own question.