Kenwood TH-D72A supports 3 types of tone: Tone, CTCSS and DCS.

What is the difference between Tone and CTCSS?

As far as I know CTCSS is basically a continuous transmission of a given low frequency signal mixed with the voice. So it's basically a simple tone, isn't it?


1 Answer 1


"Tone", displayed as "T" on the main screen, selects tone encoder + carrier squelch (your HT will send a tone, selected by the TONE Freq menu, and receive any strong-enough signal, regardless of whether it has a tone.) The transmitted tone is necessary to "open up" most repeaters so that you can talk on them.

"CTCSS", displayed as "CT" on the main screen, selects tone encoder + tone squelch (your HT will send a tone, and only open the squelch on receive if the incoming signal contains the same tone).

The CTCSS option has some advantages, in that it will ignore interference, or a far-away repeater on the same frequency that uses the same tone, and on some repeaters will also silence the repeater ident. Especially helpful if you use scanning mode and you only want the scan to stop on actual conversations.

However, there are also reasons to use the Tone option. Not every repeater has tone on its output. For the ones that don't, you can't use tone squelch, so Tone is the only valid option. Also, tone squelch might cut off a very weak signal that comes in too staticky for the tone to be heard clearly. In this case, switching to Tone might provide slightly better reception.

  • $\begingroup$ What I get for looking up the manual instead of having used the actual radio. I'll leave this to you, sir. $\endgroup$
    – Zeiss Ikon
    Jul 3, 2019 at 15:50
  • $\begingroup$ @ZeissIkon Well, the manual ought to be correct! The OQ implies that CTCSS and Tone mean the same thing. It's been a long time since I used 2m repeaters, so I can't say for sure. See the Wikipedia article I just referenced in my answer $\endgroup$
    – Mike Waters
    Jul 3, 2019 at 18:32
  • $\begingroup$ @MikeWaters I didn't read the entire manual, just skimmed a few seemingly relevant pages. The answer from hobbs - KC2G seems to be based on actually using the radio, and also makes more sense from a utility standpoint. $\endgroup$
    – Zeiss Ikon
    Jul 3, 2019 at 18:36
  • 1
    $\begingroup$ @ZeissIkon I remember being confused by the same thing when I bought my D74. The names aren't descriptive, and the manual doesn't elaborate. I had to figure it out by trial and error. My assumption is that Kenwood didn't change the nomenclature between the D72 and D74. $\endgroup$ Jul 3, 2019 at 19:12

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .