Not sure if this is the right place to ask, but I'm trying to build a system of multiple WiFi access points that are spread out across a store.

Since every smartphone and WiFi enabled device regularly sends out a "discovery"-packet to check if hotspots are around, I'm trying to keep track of that and see where people go inside that store, to have statistics on how many people that look at the display window actually go inside and to the checkout and similar things.

Now my problem is that the WiFi signal of my access points goes way too far and every smartphone gets detected on all hotspots.

How would one go about shortening the distance of a WiFi signal?

  • $\begingroup$ Most commercial WiFi systems are able to estimate client location through triangulation. Have you considered those? $\endgroup$ May 18, 2018 at 19:36

2 Answers 2


For a device to register with the access point, it must receive a transmit signal from the access point (AP). This largely consists of the AP transmitting its SSID so that it can be detected by the client device. If the client does not see the SSID, it often cannot detect the AP unless it is in active use by another client. The goal is therefore to effectively reduce the detectable range of the SSID.

One method of shortening the range is to reduce the transmit power of the AP. Many APs have a configuration menu setting that allows you to reduce the transmit power. You may wish to experiment with various settings to see what works for your situation.

Another option is to deliberately degrade the antenna performance by shortening it. This would largely be experimental and non-reversible but simply clipping the antenna shorter with a stout wire cutters will have this effect. If the AP has more than one antenna, they must all be clipped or alternatively leave only one installed and clip that antenna. Continue to clip the antenna(s) shorter until the desired range is achieved.

A third option is to use an attenuator. These devices reduce both the transmitted and received signal level. They are available in various levels of attenuation denoted by dB ratings - the large the number, the more the attenuation. Start with a 20 dB attenuator for each antenna and experiment from there. You will need to find an attenuator that fits the connectors of your AP antennas and the AP itself. Sometimes some connector adapters are required.

A fourth option is to attempt to shape the pattern of the antenna. Consider putting the AP in a larger tin can (like a popcorn can) so that it's antennas is well contained in the depth of the can. This will largely restrict the effective range to an area that projects as a cone from the open end of the can.

Keep in mind that AP frequencies are in the microwave region and are very susceptible to bouncing off of objects to reach their destination. This may frustrate some of your efforts to reduce the range. You may need to combine some of the above options to reach your goal.

  • 1
    $\begingroup$ Would a wire mesh cover work? Choose the size of the mesh holes and number of layers of mesh to get different attenuations? $\endgroup$
    – hotpaw2
    May 17, 2018 at 23:15
  • $\begingroup$ @hotpaw2 Sort of a variable Faraday cage? It might have some merit. $\endgroup$
    – Glenn W9IQ
    May 18, 2018 at 1:21

Shortening the range is a poor way of estimating distance. Different phones have different sensitivities on their WiFi radios so you won’t have a high degree of accuracy.

Instead, you should measure the relative strength of the WiFi signals. There’s some code floating around that does this in reverse for blind people in shopping malls. You should also be able to do the same with your routers although you may need either custom firmware or APIs that expose the SSIDs that the routers see and their relative strength.


You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .