I need to estimate the signal delay through the 1:4 Guanella balun shown here:
Is the delay simply the delay through the winding on CORE1 or CORE2?
For example, assume each winding comprises 0.1-m of coax with velocity factor of 0.78, is the delay: $$delay = \frac{0.1 \text{-m}}{0.78 \;\text x \;3\text x 10^8 \text{-m/s}} = 0.43 \text{ns}$$
A colleague used a 2-port vector network analyzer (VNWA) to perform a useful measurement.
After calibrating the instrument to set the phase of S21 to zero at 20-MHz - no delay - he measured the phase added by about a meter of small diameter coax as 28.49 degrees. He then wrapped the entire length of the same coax on a large toroidal ferrite core, FT240-43 (2.4-in O.D., 43-mix ferrite) and measured the phase as 28.43 degrees, indicating that "ferrite loading" of the coax added no discernible delay. This is not surprising, in hindsight, but the experimental verification is worthwhile.
I modeled a Guanella balun using SimSmith. As shown, I used the resistance and reactance specified for a binocular type-43 ferrite core to establish the impedance to currents on the outside of the coax shield at 2-MHz:
As shown by SimSmith's Wave function:
the delay from the input to the output of the balun is:
17.97ns - 17.54ns = 0.43ns
which is the delay expected from the length of coax used to wind each of T1 and T2:
$\text{delay} = \frac{\text{4-in x .0254-m/in}}{\text{0.78 x 3x}10^8 \text{m/sec}} = \text{0.43-ns}$
